DIY Band Clamp – Russia today Posting in CHAT: Russia The final stage of repairing or replacing the CV joint is installing the clamp on the rubber boot. The problem is that it cannot be tightened by hand with sufficient force. As a result, many people simply buy screwdriver clamps separately and throw away the standard ones. If you make a clamp of this design, you will be able to very securely and quickly tighten the tape clamps Materials: Profile pipe 15x15 mm M8 bolt Process of making a clamp To make a clamp you will need a piece of profile. tube 12-15 cm long. A hole with a diameter of 8 mm was drilled 5 cm from the edge. Now you need to cut the bolt to screw in the clamp. When using a 15x15 mm profile pipe, it is enough to leave on it a piece of a stick with or without thread, 20 mm long (excluding the head). Then it needs to be sawn lengthwise. The slot should be thin, so it should be made with a 1 mm disc or a hand saw for metal. Now you will have to cut the walls into tubes from the side of the hole, as done in the photo. We remove the swing that remains from the angle grinder. To use the clamp, you need to install the clamp and tighten it manually. Then you need to insert its edge into the slot of the bolt inserted into the hole in the bracket. Holding the device with one hand, you need to turn the bolt with a key or head, thus winding the tape around it. When the clamp is tightened enough, the clamp rotates towards the clamp. The tape will bend and everything is held in place. The bolt is then unscrewed and the clamp tube is removed. Source link Source link
