Many people dream of having a gazebo on their property, but cannot yet save up to buy it. It is not necessary that it have cut out and calculated elements; you can save money and make it yourself simply from an edged board. Believe me, if roses, grapes grow around it, or there is a well-groomed lawn, then even without expensive decoration and a hip roof, it will still become your favorite vacation spot. Materials: 40 mm board – 1 cube of leaves; ridge elements – 5 pcs.; self-tapping screws 4.2×75 – 500 pcs. for corrugation 30×30 – 6 pcs. flat supports made of ordinary paving slabs. In some places the soil is cut off, and where necessary, several pieces are laid in a column. The base of the gazebo in this case will be 3×2.2 m, the rest you can do at your discretion. Next, 4 boards are cut to assemble the base of the gazebo, from which you will have to build during further construction. In this case, their lengths are 3 m and 2.2 m. Now you have to assemble 2 identical pediments. The bottom is made from pre-prepared 2.2 m boards, the top is made from two 1.9 m boards converging at an angle. Each rack is made from a pair of boards, that is, 4 pieces are needed for the pediment. Their length is chosen arbitrarily, depending on the required height. It is necessary to assemble 2 identical pediments, securing the boards with self-tapping screws. The gables are installed vertically and temporarily secured with jibs. Previously sawn boards 3 m long are screwed to them from below. 2 boards are attached to the top, on which corrugation will be added, so they must extend beyond the gazebo for the roof overhangs; the board must be screwed transversely to the base of the gazebo. Then a plank floor is laid with small gaps so that water does not linger on it, and 2 more boards are screwed onto the ridge. Next, benches are assembled from planed boards. It should be U-shaped. The rear part for it will at the same time be part of the frame; to fix the necessary rigidity, another board is screwed to the roof frame and a corrugator is installed. For a gazebo of this size you will need 10 sheets. The junction of the slopes is covered with ridge elements. To increase the rigidity of the roof, additional support is required in the center of each slope. To do this, the board must be screwed to the bench. A stiffening rib will also need to be attached to its back. Finally, all that remains is to install the table.
0 комментариев